Custom Transmission Crossmember Build

[Aerocoupe]

Will be putting a Coyote and 6R80 in my F100 at some point (getting one through college so priorities are on that) and I was contemplating how to build the trans cross member. I always like the looks of a round tube cross member but was having a hard time figuring out how to make the tubular ends with urethane bushings. After a lot of searching I ran across this article and just had to share with the forum as it simple and very effective.

http://www.how-to-build-hotrods.com/cus ... ounts.html

Has anyone done anything similar?

[cep62]

That's an interesting link , thank you for sharing