Timing question FE

Engine, ignition, fuel, cooling, exhaust

Moderators: Ranchero50, DuckRyder

Post Reply
Zorm
Blue Oval Fan
Blue Oval Fan
Posts: 547
Joined: Tue Apr 14, 2009 1:28 pm
Location: Pensacola, Florida

Timing question FE

Post by Zorm »

Got the engine out, replacing the freeze plugs, water pump and timing set since I'm there. Set to TDC, (timing mark on harmonic balancer lined up to timing bracket, dizzy pointing to # 1cyl, verified with long screwdriver in #1 cylinder). Remove he timing cover and the timing marks are just a hair off. I look at the harmonic balancer and see that the painted mark that I used to set TDC is actually at 10 and not 0. I also noticed that the timing chain is kinda loose.

So, would it be due to the mark on the balancer being at 10 causing the marks to be a little off or the loose chain? With the new chain, do I line the marks back up to each other? I don't know why the timing is set at 10*, this truck been in the family since 73, its had 3 engines, not sure if this one is a 390 or 360 and who put it in. Dad passed in 08 and I got this in 09, Mom does not know any history on the truck.

thanks for help.
1971 F250 Camper Special, family owned since 1972
1983 Cherokee, last of the big ones, bought in Italy, family owned since 1998
1965 Corvair Corsa Convertible, 140 engine, 4 speed.

HE guides my path, forgives me when I stray and lights my life
User avatar
sparky72
New Member
New Member
Posts: 178
Joined: Tue May 07, 2019 8:52 pm
Location: Central CA

Re: Timing question FE

Post by sparky72 »

The PO probably set the idle timing at 10 and put a mark there to make tuneups easier. Someone had done the same thing to mine.

In theory, TDC is TDC. When you have the balancer lined up at 0°, the dots should line up real close. You could check whether it’s the chain by moving the crank back and forth to see how much play there is (should be about none).
Taylor
1972 F250 Ranger XLT 2wd / 8100 GVW / 390 / T18 / 3.73 D60
Furyus
New Member
New Member
Posts: 7
Joined: Mon Jan 13, 2020 6:05 pm

Re: Timing question FE

Post by Furyus »

I would line up the marks on the gears, and put on a new timing chain. Then your balancer should be at zero. If not, you can make a piston stop from a spark plug, and a bolt. Lots of info on making it. Rotate the engine clockwise until it stops. Make a mark on the balancer. Rotate it counter clockwise until it stops. Make a mark on the balancer. Measure the distance, and top dead center will be exactly in the middle of those marks. If it's not at top dead center, the balancer is off.
Post Reply