1969 F100 CV Swap Measurement Question

Post progress reports on your project truck(s)

Moderator: FORDification

diznasty
New Member
New Member
Posts: 59
Joined: Fri Aug 31, 2012 9:01 am

Re: 1969 F100 CV Swap Measurement Question

Post by diznasty »

Welp its in. after tightenting it up its as square as its every going to get. Moving on to the steering next. I will keep the updates coming.
You do not have the required permissions to view the files attached to this post.
diznasty
New Member
New Member
Posts: 59
Joined: Fri Aug 31, 2012 9:01 am

Re: 1969 F100 CV Swap Measurement Question

Post by diznasty »

ANy ideas for steering linkage? Looks like I am going to have to source a new shaft with a splined end. I think the late '70s trucks came with tilt columns. I might start looking for them.
You do not have the required permissions to view the files attached to this post.
chris72cv
New Member
New Member
Posts: 1
Joined: Fri Nov 09, 2012 9:30 pm
Location: Benton. Ar

Re: 1969 F100 CV Swap Measurement Question

Post by chris72cv »

hey guys its my first time on this forum . can someone give me the measurements from centerline of core support hole to the centerline of where the new holes are drilled.
i bought a 72 f100 about 3 weeks ago and a 2003 crown vic about a week ago .... ( 72) engine ,tranny is now pulled front cap is pulled. im going to take it to bare frame do all of my fab work and por15 the whole frame so any tips would be great
diznasty
New Member
New Member
Posts: 59
Joined: Fri Aug 31, 2012 9:01 am

Re: 1969 F100 CV Swap Measurement Question

Post by diznasty »

measure measure measure...The truck axle centerline is approx 22" back off teh core support holes. Your centerline for the CV is offset from the holes. Best thing to do is measure as much as you can, get it to where you think the centerlines match up then do some mock-up.
diznasty
New Member
New Member
Posts: 59
Joined: Fri Aug 31, 2012 9:01 am

Re: 1969 F100 CV Swap Measurement Question

Post by diznasty »

Selling some parts. Let me know if interested.

http://erie.craigslist.org/pts/3422000738.html
griggs69f100
New Member
New Member
Posts: 12
Joined: Thu Jan 26, 2012 8:48 am
Location: belleville wi

Re: 1969 F100 CV Swap Measurement Question

Post by griggs69f100 »

i know this is an old post . i was wondering what steering shaft that was in the picture on page two?? thank you
Post Reply