Odds and ends needed

Moderator: FORDification

Post Reply
max03
New Member
New Member
Posts: 222
Joined: Thu Nov 11, 2010 12:25 pm
Location: Pine Bluff, Arkansas

Odds and ends needed

Post by max03 »

I recently got a good deal on a 1968 f100 and need to replace afew things
I'm looking for the following: passenger side inner fender, battery tray, marker lenses on hood and rear lower part of bed, washer bottle, glove box liner w/o air, switch under dash on heater box, and last but not least the little door on the fresh air vent located on the drivers side kick panel. :fr:
72 lwb sport custom, 300/3spd
pdb,ps, ac 3.70:1
68-swb 300/3spd sold
69-lwb 390/c6 sold
69-swb 240/c4 sold
72-swb ranger xlt 360/c6 sold
72-swb sport custom 302/3spdsold
kaitlyn
New Member
New Member
Posts: 13
Joined: Sat Oct 03, 2009 11:29 am

Re: Odds and ends needed

Post by kaitlyn »

inner fender and a battery tray for 100 dollars plus shipping 909 5568229
max03
New Member
New Member
Posts: 222
Joined: Thu Nov 11, 2010 12:25 pm
Location: Pine Bluff, Arkansas

Re: Odds and ends needed

Post by max03 »

Any idea what the shipping would be to 71601, pine bluff Arkansas? Thanks.
72 lwb sport custom, 300/3spd
pdb,ps, ac 3.70:1
68-swb 300/3spd sold
69-lwb 390/c6 sold
69-swb 240/c4 sold
72-swb ranger xlt 360/c6 sold
72-swb sport custom 302/3spdsold
max03
New Member
New Member
Posts: 222
Joined: Thu Nov 11, 2010 12:25 pm
Location: Pine Bluff, Arkansas

Re: Odds and ends needed

Post by max03 »

Finally got everything that was listed, now needing hood reflected emblems, arm wrests, exterior mirrors, also a glove box mounted emergency flashed switch.
72 lwb sport custom, 300/3spd
pdb,ps, ac 3.70:1
68-swb 300/3spd sold
69-lwb 390/c6 sold
69-swb 240/c4 sold
72-swb ranger xlt 360/c6 sold
72-swb sport custom 302/3spdsold
max03
New Member
New Member
Posts: 222
Joined: Thu Nov 11, 2010 12:25 pm
Location: Pine Bluff, Arkansas

Re: Odds and ends needed

Post by max03 »

Also Looking for a in bed spare tire mount
72 lwb sport custom, 300/3spd
pdb,ps, ac 3.70:1
68-swb 300/3spd sold
69-lwb 390/c6 sold
69-swb 240/c4 sold
72-swb ranger xlt 360/c6 sold
72-swb sport custom 302/3spdsold
User avatar
Calfdemon
100% FORDified!
100% FORDified!
Posts: 2672
Joined: Tue May 25, 2010 11:31 pm
Location: California, Santa Clarita

Re: Odds and ends needed

Post by Calfdemon »

What type of hood emblems are you looking for (100, 250, 350??). As for the glove box emergency flasher, I believe I have one or 2 of them around here. Let me see if I can find them. Did you want it actually mounted in a glove box or do you already have the glove box and are just looking for the switch?

I also have an in-bed spare tire mount that I used to run on my 72. I will not be running it on my crew cab. It is not an original and is an aftermarket one I bought for $50, but it worked great and there is no drilling involved, and you can lock your tire as well with a padlock.

And I also have an extra pair of armrests that were painted green with fabric paint. You can paint them another color if you want. They are not perfect, but are definately usable and driver quality. There are no tears that you can see, only problem is that the back is partially separating on one of them, but it is out of sight and does not effect the look at all.

I can give you both the armrests, the switch, and the spare tire mount for $50 plus shipping. I can take pictures if you want to see them.
-Rich

Current toys -
69 Ford F350 Crew Cab - 460 / C6 - http://i253.photobucket.com/albums/hh67 ... lqgskp.jpg
31 Ford Vicky - 1955 270 Red Ram Hemi / 4 speed - http://i253.photobucket.com/albums/hh67 ... bsibvn.jpg

Former toys -
67 Pontiac Firebird 400 convertible (sold 9/13) - http://i253.photobucket.com/albums/hh67 ... bird-1.jpg
67 Ford Fairlane GT - 390 / 4 speed (sold 7/15) - http://i253.photobucket.com/albums/hh67 ... c5hu8z.jpg
max03
New Member
New Member
Posts: 222
Joined: Thu Nov 11, 2010 12:25 pm
Location: Pine Bluff, Arkansas

Re: Odds and ends needed

Post by max03 »

Thanks for the relply, photos would be great! That price sounds like a deal. I'm interested in everything you mentioned. As far as the hood markers, it's a f100 series.
72 lwb sport custom, 300/3spd
pdb,ps, ac 3.70:1
68-swb 300/3spd sold
69-lwb 390/c6 sold
69-swb 240/c4 sold
72-swb ranger xlt 360/c6 sold
72-swb sport custom 302/3spdsold
User avatar
Calfdemon
100% FORDified!
100% FORDified!
Posts: 2672
Joined: Tue May 25, 2010 11:31 pm
Location: California, Santa Clarita

Re: Odds and ends needed

Post by Calfdemon »

I cant help you with the hood emblems, but here are the pictures of the stuff I have that you asked about:

The spare tire carrier goes between the floor of the bed and the top piece goes under the lip at the top of the sidewall. You then tighten the center nut so that there is tension between the two and you don't drill anything. You then put the horizontal bar through one of the lug holes and tighten the wheel down with a lugnut. There is a hole in the end of the bar where you can put a padlock to lock it if you want. With the tire on the holder, you cannot access (or see) the actual tire holder so no one can loosen it and get it out of the bed. I ran my spare in my 72 this way and you can see it below in the picture of my signature (green truck).
Image

Here are the 2 greed armrests
Image

Here is the back where it is starting to come apart:
Image

I have an extra black one that is actually in perfect condition which I don't need. It is for the same side of the truck that the one with the bad back is for, so I will throw it in and if you decide to paint them, you can use the two good ones and toss the one that is coming apart.
Image

Here is the emergency flasher switch from my 69 for the glove box:
Image

If you want them, send me a PM with your address and I will get them boxed up and get a quote for the shipping. I will use FedEx as it is closest to me (not cheapest though). So $50 for all of this plus whatever FexEx is going to charge.
-Rich

Current toys -
69 Ford F350 Crew Cab - 460 / C6 - http://i253.photobucket.com/albums/hh67 ... lqgskp.jpg
31 Ford Vicky - 1955 270 Red Ram Hemi / 4 speed - http://i253.photobucket.com/albums/hh67 ... bsibvn.jpg

Former toys -
67 Pontiac Firebird 400 convertible (sold 9/13) - http://i253.photobucket.com/albums/hh67 ... bird-1.jpg
67 Ford Fairlane GT - 390 / 4 speed (sold 7/15) - http://i253.photobucket.com/albums/hh67 ... c5hu8z.jpg
max03
New Member
New Member
Posts: 222
Joined: Thu Nov 11, 2010 12:25 pm
Location: Pine Bluff, Arkansas

Re: Odds and ends needed

Post by max03 »

Pm sent
72 lwb sport custom, 300/3spd
pdb,ps, ac 3.70:1
68-swb 300/3spd sold
69-lwb 390/c6 sold
69-swb 240/c4 sold
72-swb ranger xlt 360/c6 sold
72-swb sport custom 302/3spdsold
Buckethead03
New Member
New Member
Posts: 100
Joined: Tue Oct 04, 2011 2:39 pm
Location: North Carolina

Re: Odds and ends needed

Post by Buckethead03 »

if the green arm rests don't sell i need them for my truck. green is the actual color i need
User avatar
Calfdemon
100% FORDified!
100% FORDified!
Posts: 2672
Joined: Tue May 25, 2010 11:31 pm
Location: California, Santa Clarita

Re: Odds and ends needed

Post by Calfdemon »

Buckethead03 wrote:if the green arm rests don't sell i need them for my truck. green is the actual color i need
No problem... If Max doesn't buy them, they are yours.
-Rich

Current toys -
69 Ford F350 Crew Cab - 460 / C6 - http://i253.photobucket.com/albums/hh67 ... lqgskp.jpg
31 Ford Vicky - 1955 270 Red Ram Hemi / 4 speed - http://i253.photobucket.com/albums/hh67 ... bsibvn.jpg

Former toys -
67 Pontiac Firebird 400 convertible (sold 9/13) - http://i253.photobucket.com/albums/hh67 ... bird-1.jpg
67 Ford Fairlane GT - 390 / 4 speed (sold 7/15) - http://i253.photobucket.com/albums/hh67 ... c5hu8z.jpg
Post Reply