C4 part identification help
Moderators: FORDification, 70_F100
-
Dimezilla
- New Member
- Posts: 1
- Joined: Wed Jan 25, 2012 9:05 am
C4 part identification help
I am rebuilding my c4 for the first time. Got the tranny out and the pan off. A little part was at the bottom of the pan and I dont know what it is or where it goes. I appreciate an!y help on this. Thanks
You do not have the required permissions to view the files attached to this post.
-
mmerlinn
- New Member
- Posts: 190
- Joined: Thu Jan 22, 2009 11:45 am
- Contact:
Re: C4 part identification help
You need a new case. That part is press fitted in the case. If it fell out, the hole is wallowed out where it belongs and it will not stay in if you try to reinstall it. No, you can't glue it in. It will still fall out.
mmerlinn (http://mmerlinn.com/catalog/makeridx.htm)
"People who are careless and sloppy writers are usually also careless and sloppy at thinking. Answering questions for careless and sloppy thinkers is not rewarding." - Eric Steven Raymond
"People who are careless and sloppy writers are usually also careless and sloppy at thinking. Answering questions for careless and sloppy thinkers is not rewarding." - Eric Steven Raymond
-
Donnie
- Blue Oval Fanatic
- Posts: 772
- Joined: Sat Jul 30, 2011 12:22 pm
Re: C4 part identification help
I was going to suggest a repair, but since you have it out & are going to rebuild it anyway, you may as well do as was suggested.........I saw the pin this AM but failed to read your complete post...Donnie