Resurrecting "The Rangersuarus" My 69 Ranger

[Mancar1]

I am enjoying your progress.

[69rangerf100]

dropped the 390 block off at the machine shop to be cleaned and new cam bearings installed. my painless wiring harness came in today and picked up a new sand blaster since my other one bit the dust

[69rangerf100]

so its been a while since i updated got the block back from the maching shop it had to go 30 over due to some scaring on 3 cylinder walls. repainted the block and installed the camshaft, crank, pistons and the arp head studs

[69rangerf100]

well its sad that is has been 9 months since i have updated this thread. since the last update the frame has been moved outside and i have been working on the body work on the cab. still working to get the undercoating off of it almost finished then i really start working stripping the paint off

[69rangerf100]

was finally able to do some work on the cab and got the top of the cab and the cowl sander down to bare medal. down side is that i found rust right above the drain rails above the doors not happy about that. any one got any ideas on what i should do to fill the holes. should i weld them up or use some type of patch putty hardener.