leaking dana 44 closed knuckle
Moderators: FORDification, Doug Comer
-
- Blue Oval Fanatic
- Posts: 875
- Joined: Sat Nov 06, 2010 8:55 am
- Location: south dakota
- Contact:
leaking dana 44 closed knuckle
hi all.i replace the seal and the felt wiper but it still seems to leak a bit from the lower kingpin cap any suggestions on what could cause this?thank you :help:it is on a 1971 f250. got it fixed
Last edited by 71highboy on Fri Dec 17, 2010 9:43 am, edited 1 time in total.
- 71PA_Highboy
- Blue Oval Fanatic
- Posts: 923
- Joined: Tue May 23, 2006 11:32 am
- Location: Denver of the East
Re: leaking dana 44 closed knuckle
There is a seal above the kingpin.
It is only hard to get to because you have to pull from the bottom.
Be careful if you choose to do it in the vehicle as the bearing will fall out ... make sure you don't frop it in the dirt or sand.
Good luck!
It is only hard to get to because you have to pull from the bottom.
Be careful if you choose to do it in the vehicle as the bearing will fall out ... make sure you don't frop it in the dirt or sand.
Good luck!
Got Ford?
2 EarlyBroncos (68,69)
2 Classic Mustangs (69,70)
1 F250 4x4 (71) - OB - 360, NP435, D24, HPD60 4.10, D60,
1 94 Ranger, 2.3, 5spd
1 Lincoln Mark VIII
2 EarlyBroncos (68,69)
2 Classic Mustangs (69,70)
1 F250 4x4 (71) - OB - 360, NP435, D24, HPD60 4.10, D60,
1 94 Ranger, 2.3, 5spd
1 Lincoln Mark VIII
-
- Blue Oval Fanatic
- Posts: 875
- Joined: Sat Nov 06, 2010 8:55 am
- Location: south dakota
- Contact:
Re: leaking dana 44 closed knuckle
ok thank you