OK,
So since I have been home I haven't got to work on my truck that much but haven't forgot about it. The major work will begin when I finally get out of TN, and get down to FL. Anyhow though this is what I have got going so far.
My Fordification.com Stickers on my F250! (HAD TO THROW THIS IN)
So I got three transfer cases, a Dana 21, and than realized the NP435 I got was for a bigger truck, and the spline was different, thanks to you guys here. So than I went out and got a NP205 Transfer case. So if anyone needs a real nice Dana 21 let me know, and than I have one that is going to need new seals but still worked good, I will have a decent price on them. Here are the parts to finally make my old truck 4 wheel drive again.
The new NP205 to replace the Dana 21
One of the Dana 21's this is the one I got off of a member here but am no longer going to be using.
This is my old transmission that worked great until I had a clutch put in my truck. Anyhow they took the tail shaft off, and jacked it up so I used it as an excuse to upgrade.
The next two are the bucket seats and new carpet. I also have new rims that are identical to what I have on it just nicer, the kick plates for the doors, the ford deletion plate for the radio, and all the aluminum pieces for the interior light, and ash trey that I got from here. Hopefully I have more progress than just a list of what I have collected on my next post.
And here is how the truck sets as of now!!!
I also put in a 67 mirror that I ebayed, an SOS pad, and it was shining like new!
Anyhow it is a start for sure.
