offenhauser/headers

[danno]

Does anyone have directions on how to install a offenhauser intake with holley 390cfm carb and hedman header. throttle linkage and vacuum hose routeing on a 300 six in a 69 F-100. Any help would be a great help

[Dragon]

I put a Offy dual port manifold on my Dad's 240 F100 and a Hooker header later it went on with no hassle. No mods to the linkage or anything. You lose manifold heat when you ad the header and on a winter day in Colorado it was real tough to get started in the morning.

[willowbilly3]

This might be a good time to switch to a cable throttle if you haven't already. I know many of the dentsides have them. Last spring I pulled that whole setup from a junker but I can;t remember the linkage. The DP had part of the heat area where the original manifold would attach, hacked away to clear the headers but not all headers will require that.
I strongly recommend anyone messing with a six go browse the Fordsix forum.

[MadMaxetc]

I have a 500cfm Edelbrock on mine with a Lokar cable.

check out my website for pictures...as well as photobucket.

http://s63.photobucket.com/albums/h142/ ... 300engine/

[j41385]

What hasn't been asked, unless I missed it, is this... Is it an offy c or dp?

If its a dp the front of the carb faced the passenger front tire. If its a C it faces the way you drive.

[willowbilly3]

What hasn't been asked, unless I missed it, is this... Is it an offy c or dp?

If its a dp the front of the carb faced the passenger front tire. If its a C it faces the way you drive.

Which is better for the typical street engine?

[danno]

It is a DP intake,and I want to thank you for your help,this is a great wed site

[7DF250]

Here's mine.