two barrel phenolic spacer needed.

ezernut9mm · Post by **ezernut9mm** » Sun Jul 27, 2008 12:00 am

who makes them and where to buy? i've had no luck finding one. i have a factory aluminium one, but it is warped. it took two gaskets on the carb side to seal it and i still don't think it's sealed right. the carb is true-i checked that and it is good. also, who makes good rubber vacuum caps that don't disintigrate after a couple of months like the autozone ones?

rubiranch · Post by **rubiranch** » Sun Jul 27, 2008 12:09 am

Ford used them on 302s and 351s that were equipped with variable-venturi carburetors (2700 and 7200 VVs) from about 1979-1983.

Good luck.

ezernut9mm · Post by **ezernut9mm** » Sun Jul 27, 2008 12:39 am

i'm gonna need it. i haven't found one in any catalog except for a rochester 2bbl. i wonder if the bolt patterns are the same. prolly not.

basketcase0302 · Post by **basketcase0302** » Sun Jul 27, 2008 4:27 am

EZ,

For many years now I've taken the EGR valves and "gutted" them, plugged the 1/2" hole and used them for this.

Aluminum usually though, not phenolic.

Jeff

rubiranch · Post by **rubiranch** » Sun Jul 27, 2008 1:42 pm

ezernut9mm wrote:i'm gonna need it. i haven't found one in any catalog except for a rochester 2bbl. i wonder if the bolt patterns are the same. prolly not.

Nope, not the same bolt pattern.

The FORDification.com Forums

two barrel phenolic spacer needed.

two barrel phenolic spacer needed.

re: two barrel phenolic spacer needed.

re: two barrel phenolic spacer needed.