Leafspring hanger (half) flip

[WhitsEnd]

I needed to lower the rear of my truck to get the stance right with my Crown Victoria front end. My front end sits 5/8" higher than most CV swaps because of the way I did it, so I didn't want the rear super low. Also, I still want to use this as a truck: hauling light loads and such.

I decided to flip the front spring hangers on the rear suspension to get the 3" drop I was after. There are several threads on how this is done.

This is how I did mine. http://www.fordification.com/forum/view ... 85#p748863